What Size Socket Works with 1 Inch Spindle Castle Nut # 165686?  

The Trailer Idler Hub Assembly for 3,500-lb E-Z Lube Axles - 5 on 4-1/2 - Galvanized #AKIHUB-545-35-G-EZ-K does not come with the spindle nut. That would come with your axle. For a 3,500 lb axle you would want the Spindle Nut Kit for EZ Lube Axles…

What you have is an 86" long axle with a 4,400 lb capacity. Since 4,400 lb axles are no longer being produced, you will need an axle with a higher capacity for a replacement. I recommend the Trailer Axle Beam with Easy Grease Spindles #e45GR.…

Certain types of grease are compatible with each other but since you do not know what type is in your trailer now we recommend that you remove the existing grease from your trailer wheel bearings before refilling them. Even if you know what type of…

The #168233 Double Lip Grease Seal has an outside diameter of 2.332 inches and an inside diameter of 1.688 inches. This seal is not compatible with a AF2527E seal with a O.D 2.312, because, even though the O.D. id very close, the inner diameter of…

You are looking for the Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles - Qty 2 part #RG06-050 just like the ones you previously ordered two of these come in a pack.

In almost all cases 3,500 lb axles will all use the same bearings. If your trailer has a Lippert or Dexter 3,500 lb axle then yeah they would be the same. But to be safe it won't hurt to pull them off and get the numbers. If you are sure you need…

The best way to identify replacement grease seals (and bearings and races) is by the original part reference number. The linked photo shows the typical location and appearance of these part numbers. It can be a bit of work to get the parts clean…

As long as you install an idler hub on your 2021 Load Rite Trailer then the Kodiak Disc Brake Kit - 10" Rotor - 5 on 4-1/2 - Stainless Steel - 3,500 lbs #K2R35S will fit just fine. Now to determine which idler hub will fit your 3700lb knott…

The castle nuts do not have a torque spec. Bearings and races are fit to the spindle precisely and will have minimal movement to the washer and castle nut which will simply be tightened and held in place with the cotter pin #165649. We recommend…

Good news! I was able to go out to the warehouse and measure the etrailer landing gear #RVLG-8HDL for you. I found that the distance between the weld stops from the outside to outside is 17-1/2 inches and from the inside to the inside of the weld…

I don't have any way of determining if the Replacement Crank Handle for etrailer and Ram 5th Wheel Landing Gear #RVLG-HDL will work with your 2007 Fleetwood Nitrous Hyperlite TT Toy Hauler or not, unfortunately. The Replacement Crank Handle…

EZ Lube spindles are generally preferred over Bearing Buddy setups. The EZ lube allows you to insert grease down the middle of the spindle easily which is basically the best option aside from removing the hub and taking it all apart and cleaning and…